
CK-SN960 P
ENDANT
Wireless panic pendant for personal safety
and protection.
Power requirements : one 6 Volt lithium
battery (included)
Operating temperature : 0°C ~ 60°C
Transmission power : 100 mW
Transmission frequency : 902 - 928 MHz
spread spectrum
CK-SN961 K
EYFOB
This four button remote transmitter is used to arm or disarm the
Sierra
®
systems remotely. For personal safety this keyfob includes
two buttons that, if pressed simultaneously, can send a panic signal
to the central monitoring station and/or sound the alarm. Designed for
use with the SN915-BUS receiver.
Power requirements : one 6 Volt lithium battery (included)
Operating temperature : 0°C ~ 60°C
Transmission power : 10 mW
Transmission frequency : 902 - 928 MHz spread spectrum
CK-SN970 P
ANIC
B
UTTON
Wireless panic button transmitter.
Power requirements : two 3.6 Vdc
1
/
2
AA lithium
batteries (incl.)
Operating temperature : 0°C ~ 60°C
Transmission power : 100 mW
Transmission frequency : 902 - 928 MHz
spread spectrum
Mounting location : on any wall, counter, desk or portable
CK-SN971 H
OLD
-
UP
B
UTTON
Wireless 2-button hold-up transmitter.
Power requirements : two 3.6 Vdc
1
/
2
AA lithium
batteries (incl.)
Operating temperature : 0°C ~ 60°C
Transmission power : 100 mW
Transmission frequency : 902 - 928 MHz
spread spectrum
Mounting location : on any wall, counter, desk or portable
CK-SN972 R
AIL
RF foot-rail transmitter.
Power requirements : two 3.6 Vdc _ AA lithium batteries
(included)
Operating temperature : 0°C ~ 60°C
Transmission power : 100 mW
Transmission frequency : 902 - 928 MHz spread spectrum
Mounting location : on any floor
B
ATTERIES
After RF transmission performance, battery life is the second most
important issue in a wireless system. SpreadNet uses lithium
chemistry for its battery technology. This type provides high on-
demand current, with long, consistent voltage over the life of the
battery and is well suited for RF transmitter designs.
S
PREAD
N
ET
AA B
ATTERY
Voltage : 3.6 Vdc
S
PREAD
N
ET
1
/
2
AA B
ATTERY
Voltage : 3.6 Vdc
B
ATTERY FOR
P
ENDANT
Voltage : 6 Vdc
A
CCESS
C
ONTROL
DIGITAL ACCESS KEYPAD FOR SECURITY AND DOOR STRIKE
APPLICATIONS
The EDS18P is a fully programmable microprocessor based keypad
designed for door-strike applications and remote control of a security
control panel.
CK-EDS18P K
EYPAD
Voltage : 10 ~ 15 Vdc
Security codes : 4 different (4 digit) codes (10.000
combinations each); one master code and
3 user codes
Indication LEDs : green: power
red: key relay activated
yellow: auxiliary relay activated
Activation times : key / auxiliary relays latch or 0.01 - 99.99 s
momentary
Operating temperature : -20°C ~ 50°C
12
Commenti su questo manuale